Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
To assemble sander:
Move sander pallet/box to an appropriate
1.
location, as described in Site Considerations
on Page 8. Leave sander on pallet until
instructed to move it in Step 17.
Note: We recommend assembling the stand
upside down. To make it easier, have an assistant
hold the pieces while you assemble the stand.
DO NOT final-tighten stand bolts until
stand components have been assembled.
Model G0458ZX (Mfd. Since 11/23)
HEAVY LIFT!
Mount a top long bracket to a stand leg and
2.
secure by hand with (2) M8-1.25 x 15 carriage
bolts and (2) M8-1.25 flange nuts, as shown
in Figure 5.
Mount a bottom long bracket to stand leg and
3.
secure by hand with (1) M8-1.25 x 15 carriage
bolt and (1) M8-1.25 flange nut, as shown in
Figure 5.
x 3
Leg
Top Long Bracket
Figure 5. Top and bottom long brackets secured
to stand leg.
Secure a second leg to top and bottom long
4.
brackets, as shown in Figure 6.
Figure 6. Completed stand leg assembly.
Repeat Steps 2–4 to build second stand leg
5.
assembly.
Bottom Long
Bracket
x 3
Leg
-9-
Advertisement
Table of Contents
