Table of Contents
Advertisement
14. Secure stand to sander with (4) M8-1.25 x
20 hex bolts, (8) 8mm flat washers, and (4)
M8-1.25 hex nuts (see Figure 10).
x 4
Figure 10. Mounting sander to stand.
15. Lift up on stand and remove blocks.
16. With help from an assistant, carefully tilt
sander upright, as shown in Figure 11, so
rear legs touch the floor.
Figure 11. Tilting sander upright.
-16-
If the legs start to slide when tilting, you
MUST have a third person hold the stand
from sliding to avoid personal injury or
machine damage!
17. Slide table elevation handwheel over shaft
pin (see Figure 12) and secure with (1) 5mm
flat washer and (1) M6-1 x 35 cap screw.
Shaft Pin
Figure 12. Installing table elevation handwheel.
Model G0458Z (Mfd. Since 01/23)
Slots
Advertisement
Table of Contents
