Table of Contents
Advertisement
8.
Wrap sandpaper around drum (see Figure 20),
ensuring there are no bubbles or overlapping
edges.
Figure 20. Wrapping sandpaper around drum.
9.
When sandpaper reaches right side of drum,
move sandpaper out of the way with a 4mm
hex wrench and place it into access hole.
10. Rotate drum toward you so hex wrench rests
against frame, as shown in Figure 21.
Figure 21. Hex wrench inserted into access hole
on right tension wheel.
-24-
Hex
Wrench
Access
Hole
11. Firmly hold down sandpaper with both
hands, rotate drum toward you, then wrap
end of sandpaper over top of the drum
(see Figure 22).
Note: Only put enough tension on sandpaper
so it fits into clamp in next step. Do not over-
tighten it. Doing so can damage drum spring.
Figure 22. Wrapping sandpaper over tension
wheel.
12. Place end of sandpaper into clamp, secure
it, and remove hex wrench from access hole.
Sandpaper should seat flat against roller and
not overlap at any point.
— If the sandpaper does not fit into the right
clamp, you may have inserted sandpaper
too deeply into left clamp. Also, check to
make sure the length, width, and angled
cuts match the pattern in Figure 18. Make
adjustments to sandpaper if necessary.
— If sandpaper completely covers access
hole, you may have placed too little sand-
paper into left clamp. Unwrap sandpaper
and repeat Steps 7–12.
13. In either case, re-install sandpaper, repeat
Steps 7–12, and continue adjusting paper
until it fits into clamp.
14. When finished, reconnect dust collection
system.
Model G0458Z (Mfd. Since 01/23)
Advertisement
Table of Contents
