Table of Contents
Advertisement
To track conveyor belt:
1.
Turn conveyor belt ON and watch it track.
— If the belt tracks evenly, leave it alone.
— If the belt tracks toward the right, loosen
lock nut shown in Figure 37 and rotate the
right-side conveyor belt adjustment bolt
counterclockwise to move belt left.
— If the belt tracks toward the left, loosen
lock nut shown in Figure 37 and rotate the
right-side conveyor belt adjustment bolt
clockwise to move belt right.
Lock Nut
Figure 37. Conveyor coarse tracking controls.
2.
After adjustments are made, run machine for
approximately 15 minutes to watch the track-
ing adjustments you made. Be patient, belt
tracks slowly.
— If the belt tracks evenly, leave it alone.
— If the belt moves to one side, immediately
stop the machine and adjust the belt track-
ing before running the conveyor again.
Proceed to Step 3.
-34-
Conveyor Belt
Adjustment
Bolt (1 of 2)
3.
Loosen lock nut (see Figure 38) on side that
conveyor belt tracks towards and tension
tracking adjustment screw until conveyor belt
tracks in opposite direction.
Note: Small tracking changes may take up to
three minutes before they are noticeable.
Lock Nut
Figure 38. Conveyor fine tracking controls.
4.
When conveyor belt is near the middle of the
rollers or table, loosen tracking adjustment
screw until feed belt stops moving and tracks
straight.
— If conveyor belt tracks too far to the other
side, loosen tracking adjustment screw as
necessary to bring it back.
5.
Repeat Steps 3–4 until tracking is correct.
Model G0458Z (Mfd. Since 01/23)
Tracking
Adjustment
Screw (1 of 2)
Advertisement
Table of Contents
