Programing; Programing Adjustments - HBX HydroBloc 0100 Installation Manual

Control Systems Inc.
HYDRobloC HeaTInG: PRoGRaMMInG
Set
90.0
°F
Temp
System
If you allow the control to idle in Programming Scroll Mode for thirty seconds the control will automatically return
to status mode.
Set
90.0
°F
Temp
System
HYDRobloC HeaTInG: PRoGRaMMInG aDjUsTMenTs
Set
190.0
°F
Boiler Temp
Design boiler Temperature
This is the design boiler temperature.
It is used in the outdoor reset design
calculation and is also the maximum
setting for the boiler.
(50°F-200°F) Default: 190°F
Programming scroll Mode
To enter this mode the dial must be pressed in for more than 1 second. When
the SET indicator comes on release the button, you will now be in
programming scroll mode.
In this mode turning the dial to the left or right will scroll through the
programming options on the control. Each setting will be indicated by the
icons around the screen as well as the temperature of that setting. There are 11
settings to be set in the programming scroll mode.
Programming Change Mode
To change a setting you must press the dial in momentarily and an arrow will
appear in the top left corner of the screen. This will indicate the control is in
the programming change mode. While in the change mode the user will be able
to change the setting of that selection by turning the dial to the left to decrease
the setting and to the right to increase the setting. Once you have finished
changing the setting press the dial momentarily and the arrow in the top left
corner will disappear. This will indicate that the user is no longer in
programming change mode.
Set
PSI
System
Mixing adjustment
see HYD-0100-04 Drawing. Once
off is selected the Hydrobloc will
no longer show pressure and it will
use the Strap-On System Sensor to
sense the temperature. By using a
different system sensor this allows us
to still provide boiler protection.
Note: You will have to attach the
new system sensor to the low
temp. system (pg 5).
(On/Off) Default: On
H B X H Y D 0 1 0 0 H y d r o B l o c
Set
°F
Celcius or fahrenheit
Use this setting to change the display
format from °C to °F.
(°C/°F) Default: °F
H y d r o B l o c M a n u a l P a g e 9
V e r s i o n 2 . 1 0