Programming Mode - LG F1069FD2P Owner's Manual

PROGRAMMING MODE

: You can check machine information or change setting on Program setup, Collect Information Data,
Diagnostic Test.
There are two methods that you can enter programming mode.
how to enter Programming mode
You can enter programming mode only for Idle
state and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Turn on/off the toggle switch of the coin
meter.
2) Display will show
- OPL Type
1) Push the Hot & Cold button at the same
time.
2) Push the Warm button 3 times.
3) Push the Start button.
4) Display will show
- coin type -
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type
.
.
.
Insert Debit Card
- card type -
how to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
Press Button
Move to upper level or
Hot
Comes back to Idle State
Move to the mode in the
Warm
Move to the modes in the
Cold
Start Enter the selected mode
PROGRAMMING MODE PROGRAMMING MODE
Description
same level (+)
same level (-)
- OPL type -
23 23