Supplying Power (Battery Charge/Use/Refresh/Care, Ac Adaptor); Charging The Battery Pack; Using The Battery Pack - Panasonic Palmcorder PV-L354-K Operating Instructions Manual

Camcorder model no. pv-l354-k
Table of Contents

Advertisement

Available languages

Available languages

• We recommend using a Panasonic battery.
• We cannot guarantee the quality of this Camcorder when batteries from other companies are used.

Charging the Battery Pack

Charge Battery Pack fully before use.
3
2
POWER
Lamp
CHARGE
Lamp
A
B
(Top View)

Using the Battery Pack

A fully charged Battery provides a maximum of about 1 hour of continuous use (LCD
monitor off) or about 40 minutes (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
a
A
b
B
Battery Refresh
This feature completely discharges
Battery before recharging begins.
Use after every 5 charges for optimum
Battery performance.
REFRESH
Lamp
BATTERY
REFRESH
02.L354K Getting p9-16
Supplying Power
1
Plug in AC Adaptor.
POWER Lamp lights.
2
Insert Battery.
A
Align left side of Battery with left edge of
AC Adaptor.
B
Press Battery down and slide in direction
of arrow.
1
The CHARGE Lamp flashes, then stays lit
when charging is complete.
3
Remove Battery.
Slide Battery to the left and lift off.
Note:
• Charging takes about 50 minutes.
• While the DC Power Cable (supplied) is connected
to the AC Adaptor, the Battery cannot be charged.
• After charging 5 times, use Battery Refresh feature
as explained below.
• Battery life gradually decreases after repeated use
and recharging. If operation time becomes very
short even after a sufficient charge, discard Battery
properly (pages 10, 38).
A
Lift up EVF and attach Battery.
a
Insert top of Battery into top of mounting
surface.
b
Press and snap into place.
B
Remove Battery.
Slide BATTERY RELEASE and remove
Battery.
To use battery refresh, insert Battery on AC
Adaptor (see steps 1~2 above), then press
BATTERY REFRESH.
The REFRESH Lamp lights, then goes out when
discharge is complete. Battery charging will then
start automatically.
If BATTERY REFRESH is pressed by mistake,
remove Battery from AC Adaptor and reinsert it
for normal charging.
Note:
• Charging takes about 4 hours when Battery
Refresh is used.
• Battery will not operate in extremely high
temperatures.
9
9
04.1.6, 0:22 PM

Advertisement

Table of Contents
loading

Table of Contents