Dmx 512 Connection - Beamz Matrix 22 Quad Moving Head Instruction Manual

DISPLAY
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
DMX ADDRESS AND DMX MODE
Press the "UP" or "DOWN" button until "A001"
shows in the display and confirm with
"ENTER".
Now use the "UP" or "DOWN" button to select
the DMX address mode or DMX channel mode.
DMX address mode
Select "Addr" and confirm with "ENTER".
Now you can select the start address to press
"UP" or "DOWN" button and choose a value
between A001 and A512.
Confirm start address with "ENTER, "SAVE"
will showed in the display.
DMX mode
To change the DMX Channel mode, use the
"UP" or "DOWN" button to select the menu
"CH3". Press "ENTER" and use the "UP" or
"DOWN" button to select DMX mode (3Ch,
8Ch, 13Ch, 25Ch).
Confirm DMX mode with "ENTER, "SAVE" will
showed in the display.
4
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode/Esc-button, browse through the submenu by pressing Up
or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode/Esc-button. The functions
provided are described in the following schedule.