Remote Control; Replacing The Fuse; Fixture Cleaning - Beamz Matrix 22 Quad Moving Head Instruction Manual

MASTER/SLAVE
1. Connect all fixtures with 3pin DMX cable, see
above section "DMX-512 connection".
2. Press the "MODE" button, display shows "SET"
and confirm by "ENTER". Use the "UP" or "DOWN"
button until display shows "MAAL" and confirm by
"ENTER" again.
3. You can choose between Master(MASt) or Slave
(ALon). The first unit must be activate by Master and
all following units must be activate by Slave.
Confirm your selection with "ENTER". Now the
slave units follows the master unit.

REMOTE CONTROL

To control the Moving Head easily
more than 30 feet away.
STAND BY - Press this button to
PAN/TILT – After activating the IR remote by pressing "STANDBY" you can change the Pan/Tilt
positions. The Tilt position can be changed using the 2 (up) and 8 (down) buttons. The Pan position
can be changed using the 4(left) and 6(right) buttons.
FULL ON - Press this button
GOBO – No function
"DIMMER +" and "DIMMER -" – Press this button to adjust the
STROBE - Press this button to activate the strobe and select the speed with 1-7 buttons.
COLOR - Press this button to select the individual colour via 1-4 buttons. (1 Red; 2Green; 3 Blue; 4
White). Adjust the brightness level via "DIMMER +" and "DIMMER
SOUND ON & OFF - These buttons activate and deactivate the sound active mode.
SHOW - Press this button to active the show mode. Use the 1-7 buttons to select your desired built-in programs.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.

FIXTURE CLEANING

The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
•
detected
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
•
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
via the supplied remote control,
activate the IR remote control.
to switch on the LED illumination.
you must aim the remote at the front of the fixture and be no
The display shows "STOP".
brightness level.
-".
5