Table of Contents
Advertisement
FLEXCOOL
35
UnpacKinG The flexcool™ 35
The packaging of the cooler is designed to withstand shipping
abuse. If any shipping damage has occurred, contact your certified
Lincoln distributor or service center. When unpacking the unit,
avoid thrusting sharp objects through the carton, which may
damage the machine. Below is the recommended procedure for
unpacking the cooler:
• Cut and remove banding straps around skid and carton
• Remove carton
• Cut and remove banding straps around skid and cooler
• Remove cooler, literature, and other items
Save the instruction manual and service directory supplied with
the FlexCool™ 35 for parts orders and future maintenance
service.
MoUnTinG The flexcool™ 35 UnDeRneaTh The
flexcUT™ 200
The FlexCool™ 35 can be mounted underneath the FlexCut™ 200
machine or by itself on a flat surface. No power source should
ever be installed underneath the FlexCool™ 35.
Securing the FlexCut™ 200 to the FlexCool™ 35 (see Figure A.1):
1. Begin by setting the FlexCool™ 35 on a hard flat surface.
2. Remove the two 7/16" bolts and the locking bracket from the
front mounting bracket
3. Lift the FlexCut™ 200 and place on top and slightly forward
of the FlexCool™ 35
4. Carefully guide the FlexCut™ 200 so that the quick lock feet
on the bottom of the power source slide into the channels of
the mounting brackets on top of the FlexCool™ 35. Be sure
all 4 feet are within the channels.
5. Slide the FlexCut™ 200 all the way back so that it is sitting
exactly overtop of the FlexCool™ 35. The feet should be all
the way at the back of the channels.
6. Replace the locking bracket into the front mounting bracket of
the FlexCool™ 35. Torque both 7/16" bolts to 50 in-lbs.
FIGURE A.1
fillinG The coolanT ReSeRVoiR
RECOMMENDED COOLANT
BK500695 - TORCH COOLANT
(SOLD IN 1 GALLON JUGS)
WARNING
DO NOT USE: Automotive anti-freeze that contains rust
inhibitors or leak stoppers. These coolants will damage the
pump and block the small internal passageways of the heat
exchanger, affecting cooling performance.
To avoid freeze damage and fluid leakage in shipment, the
FlexCool™ 35 unit is delivered with very little coolant in the
system. To fill the unit, unscrew the plastic reservoir cap from the
front middle of the unit.
The opening of the reservoir neck mates with most coolant
containers, but to avoid spillage of coolant, a funnel should be
CAUTION
placed into the reservoir hole when filling the FlexCool™ 35.
Pure solutions and mixtures of, or materials (i.e. towels)
wetted with ethylene glycol are toxic to humans and
animals. They must not be haphazardly discarded,
especially by pouring liquids down the drain. Contact the
local EPA office for responsible disposal methods or for
recycling information. Avoid unnecessary contact.
A-3
INSTALLATION
Advertisement
Table of Contents
