Installation; Location; Stacking; Tilting - Yeswelder MIG-205DS Operator's Manual

INSTALLATION

TECHNICAL SPECIFICATIONS: MIG-205DS
INPUT-SINGLE PHASE ONLY
Standard Voltage/Frequency
220V±10% 50/60Hz
110V±10% 50/60Hz
RATED OUTPUT-DC ONLY
Voltage Duty Cycle
Mode
GMAW
100%
220V SMAW
100%
GTAW
100%
GMAW
100%
110V SMAW
100%
GTAW
100%
OUTPUT RANGE
Open Circuit
Voltage
Mode
Voltage
GMAW
220V
SMAW
GTAW
GMAW
110V SMAW
GTAW
OTHER PARAMETERS
Machine Power Factor Efficiency
MIG-205DS 1 ≥80%
PACKING DIMENSIONS
Length
Machine Width
510mm 330mm
MIG-205DS
TEMPERATURE RANGE
Operating Temperature Range
-10°C~+40°C(14°F~104°F)
Input Current
I1 =34A, I1 =26.3A
max eff
I1 =43A, I1 =33.2A
max eff
Volts at Rated
Current
Current
60% 205A 24.2V
158A 21.9V
60% 180A 27.2V
139A 25.5V
60% 205A 18.2V
158A 16.3V
60% 160A
22V
123A 20.1V
60% 145A 25.8V
112A 24.5V
60% 160A 16.4V
123A 14.9V
Welding Welding
Current Range Voltage Range
30A~205A 15.5V~24.2V
20A~180A 20.8V~27.2V
20A~205A 10.8V~18.2V
65V
30A~160A 15.5V~22V
20A~145A 20.8V~25.8V
20A~160A 10.8V~16.4V
Protection Class Insulation Class
IP21S
Height
Weight
395mm 16Kg
Storage Temperature Range
-25°C~+55°C(-13°F~131°F)
Read entire installation section before you starting in-
stallation.
ELECTRIC SHOCK can kill.
Only qualified personnel should perform
Ÿ
this installation.
Only personnel that have read and un-
Ÿ
derstood the MIG205DS Operator's Man-
ual should install and operate this equip-
ment.
Machine muse be plugged into a receptacle which is
Ÿ
grounded per any national, local or other applicable electrical
codes.
The MIG205DS power switch is to be in the OFF("O") position
Ÿ
when installing work cable and gun and when connecting
power cord to input power.
SELECT SUITABLE LOCATION
Locate the MIG205DS in a dry location where there is free cir-
culation of clean air into the louvers in the back and out the
front of the unit. A location that minimizes the chance of dirt ac-
cumulation that can block air passages and cause overheating.

STACKING

F
MIG205DS cannot be stacked.

TILTING

Each machine must be placed on a secure, level surface, di-
rectly or on recommended cart. The machine may topple over if
this procedure is not followed.
- 05 -
INSTALLATION
WARNIG