Table of Contents
Advertisement
Remove the MIG torch consumables.
Ÿ
Untie the new liner.
Ÿ
Push the liner firmly into the torch lead
Ÿ
and tighten retaining nut.
Loosen the outlet guide tube screw.
Ÿ
Feed the extended graphene liner into
Ÿ
the outlet guide tube hole of the machine
Euro connector.
Cut the extended liner with a sharp knife.
Ÿ
The remaining part should be about
14ga~12ga away from the wire drive
roller.
Remove the liner retaining nut.
Ÿ
Feed the liner in short forward move-
Ÿ
ments down the cable assembly all the
way through and out the torch end.
Disengage the drive roller.
Ÿ
Remove the outlet guide tube from the
Ÿ
front-end euro connector using long
nose pliers.
Feed the extended graphene liner over
Ÿ
the drive roller into the inlet guide tube
part.
Install the correct sized U Knurled Drive
Ÿ
roller, and with the correct diameter knurl
inside.
- 17 -
Pull out the liner completely.
Ÿ
Install a matched contact tip and other
Ÿ
front-end accessories to the torch. It is
ready for welding.
Use a screwdriver or other sharp object
Ÿ
to push out outlet guide tube through the
Euro connector.
Unscrew the inlet guide tube from the
Ÿ
wire feeding mechanism.
Tighten the torch Euro connection to the
Ÿ
Euro connector.
Remove the metal tube from the inlet
Ÿ
guide tube.
Hide quick links:
Advertisement
Table of Contents
