Controls And Settings - Yeswelder MIG-205DS Operator's Manual

Controls and Settings

1. Adjustment knob:
1). Press and select welding parameters;
2). Rotate and adjust the values.
2. Process Selection Button: Allows the user to toggle between processes Synergic MIG/Manual
MIG/Lift TIG/Stick.
3. Material Selector: CO
4. Wire Feed Button: Press the Wire Feed button to feed the wire through the gun assembly.
5. Wire Diameter Selector Button: .023" 0.6mm/.030" 0.8mm/.035" 0.9mm/.045" 1.2mm.
6. Selector Button: Permits selecting Output Current, Output Voltage, Welding Speed.
7. Gun Connection (Euro Connect): Permits attachment of a MIG welding gun. Ensure the gun is
fully seated into the brass receptacle.
8. Wire Drive Polarity Lead: Permits configuring the wire drive to positive or negative polarity by
inserting into the positive or negative receptacle. Ensure connector is tightly locked into place by
rotating clockwise.
9. Spool Gun Trigger Connector Receptacle: Plug the 2 pin gun trigger connector into this
receptacle.
10. Positive Output Receptacle: Permits attaching a work lead, electrode stinger or the center wire
drive polarity lead to DC positive polarity. Rotate clockwise to lock into place.
11. Negative Output Receptacle: Permits attaching a work lead, electrode stinger, or the center
wire drive polarity lead to DC negative polarity. Rotate connector clockwise to lock into place.
12. Power Switch: Turns power on and off to the machine.
13. Gas Inlet: Shielding gas connects to this inlet, gas fitting: 5/8"~18 RH.
14. Input Power Cable.
15. Fan.
100%/CO 25% Argon 75%/Flux Cored/AL.
2 2
2
3
6
5
4
- 08 -
1