Sync Connector - Siemens SIMATIC EB 200P-3 Equipment Manual

6.3

Sync connector

BNC connection
You can assemble the BNC connector for synchronization measurement. The following table
describes the pinouts of sync connectors. The DIP switches S2603 #1 and #2 select between
GPIO[9] and GPIO[0], respectively.
Connector name: X1203
Connector type:
Pin assignment of external synchronization connector
* Configured by DIP switch S2603, but only one input or output can be connected at one time.
BNC socket
The EB 200P-3 has the following I/O on the SYNC BNC connector:
• One SYNC_IN input available on GPIO[9] = PNCLKA_IN
• One SYNC_OUT output available on GPIO[0] = ISOPLL_OUT0
Figure 6-2 BNC Sync Connector
There are two DIP switches on S2603, but no more than one DIP switch can be ON at a time.
Evaluation Board for ERTEC 200P-3
Equipment Manual, 06/2023, A5E52825940-AA
BNC
Signal Pin
BNC Tip
Shield
Connectors of the EB 200P‑3
6.3 Sync connector
Signal
Sync In/Out*
GND
45