Channel Space Switching; (Rc-R0608.) - Kenwood VR Series Instruction Manual

VR/KRF-V SERIES (En/KM)
Preparingthenmotecontrol(RC-R0608)
Speaker placement
Front speakers
: Place to the front left and right of the listening
position. Front speakers are required (or all surround modes.
Center speaker
: Place front and center. This speaker stabilizes the
sound image and helps recreate sound motion. Be sure to connect
a center speaker when using the Dolby 3 Stereo mode.
Surround speakers
; Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately t meter
above the ears of the listeners. These speakers recreate sound
motion and atmosphere. Required for surround playback.
Subwoofer
: Reproduces powerful deep bass sounds.
• Although the ideal surround system consists of all the speakers
listed above, if you don't have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the
speaker settings steps to obtain the best possible surround repro¬
duction from the speakers you have available. -QS
Channel space switching
(Bxceptfor m USA, CMa»aa, UK, BurofiC atul AagtnUa)
The space between radio channels has been set to the one that
prevails in the area to which the system is shipped. However, it the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from area
1 or area 2 shown in the following table or vice versa, proper reception
of AM/FM broadcasts cannot be expected. In this case, change the
channel space setting in accordance with your area by referring to
the following table.
USA, Canada and South
American countries
CHANNEL
Space Frequency
FM: 100 kHz
AM: 10 kHz
Loading the batteries
O
Remove the cover.
^ Insert the betteriee.
O Close the cover.
*
Insert four AAA-size (LR03) batteries as indicated by the polarity
markings.
Operation
When the STANDBY indicator is lit. the power turns ON when you press
the
POWER
key on the remote control. When the power comes ON.
press the key you want to operate.
Operating range
(Approx.) Remote sensor
Model: RC-R0eO8
Infrared ray ayatem
»When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
O Turn povrer off.
O Hold down the BAND key of tha main unit for more then 2
saconde.
Perform each of tha following atapa within 5 eaconda.
O
Select tha mode by using tha MULTI CONTROL knob of tha
main unit.
Each press switches tha space fraquancy altarnataly.
O "FSO/AS" (FM 50 kHz. AM 9 kHz)
Lo "F100/A10"(FM 100 kHz. AM 10 kHz)
F50/R3
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checjcs.
2. Replace all four batteries with new ones when you notice a shortening
of the distance from which the remote control will operate or it the
remote control blinks 5 times when you press a key. The remote control
is designed to retain set up codes in memory while you change
batteries.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
O Eatablish the selection by pressing the BAND key.