Lint Screen; Lint Removal - Whirlpool Thin Twin LT5005XM Use & Care Manual

Lint screen
Clean the lint screen before each load. A screen blocked by lint c
increase drying time and may be a FIRE HAZARD.
The lint screen IS
Inside the dryer pull
drum, on the
Dack wall
2. Lightly
squeeze the
boay S.S
shown while
I. Use tno finger
holes 73 pull
?'-te III'
screen 5. LCOI; :Irv ,?f:
the
WARNING: DO NOT run the
dryer with the lint screen
loose, damaged or missing
Doing so can cause over-
heating, can damage fabrics and
can be a FIRE HAZARD.
an
V'OU' ilpiqeF; . .
DO NOi
rinse
Squeeze body;
pull cover off.
or wash the
screen. Wet lint is hard to remove.
4. Replace the cover on the body of
the lint screen
5. Push the lint screen straight back
in until It clicks into place
Lint removal
Lint can gather inside the dryer and create a fire hazard
This lint should be removed every 2 to 3 years, or more often,
depending on dryer usage.
Cleaning should be done only by a qualified service person.
1. Remove bock panel from dryer
2. Avoid touching thermostats,
wires, terminals and heater box.
3. Remove lint from shaded area
- see art -- with a soft brush or
vacuum cleaner.
4. Replace back panel Recon-
nect exhaust duct, etc
Level the washer/dryer
l
Avoid electrical shock
hazard - unplug power
supply cord or turn off
electrical power.
l
Avoid injury or damage-do
not
put hands inside cabinet.
. Metal edges may be sharp.
l
Make sure dryer is cool.
Thermostats
( 'j Heaty Fox
Heat Elemekt Termmals
15