Caution Notices; Warning Notices - IBM AS/400 Repair And Parts Manual

DANGER
To prevent a possible electrical shock when installing the system, ensure that the power
cords for all devices are unplugged before installing signal cables.
(RSFTD202)
DANGER
To prevent a possible electrical shock when adding or removing any devices to or from the
system, ensure that the power cords for those devices are unplugged before the signal
cables are connected or disconnected. If possible, disconnect all power cords from the
existing system before you add or remove a device.
(RSFTD203)
DANGER
To prevent a possible electrical shock during an electrical storm, do not connect or discon-
nect cables or station protectors for communications lines, display stations, printers, or
telephones.
(RSFTD003)
DANGER
To prevent a possible electrical shock from touching two surfaces with different electrical
grounds, use one hand, when possible, to connect or disconnect signal cables.
(RSFTD004)
DANGER
To prevent power from switching on automatically during service procedures, select
manual mode on the system unit control panel.
(RSFTD212)
Caution Notices
A caution notice calls attention to a situation that is potentially hazardous to people because of some
existing condition.
CAUTION:
The circuit card contains lead solder. Do not burn. Discard the circuit card as instructed by local
regulations.
(RSFTC234)
CAUTION:
This assembly has a circuit card that contains lead solder. Do not burn. Discard the assembly as
instructed by local regulations.
(RSFTC235)
Warning Notices
A warning notice indicates the possibility of damage to a program, device, system, or data.
vi
AS/400
940219404
Models 2xx Repair and Parts