IBM AS/400 Repair And Parts Manual page 43

d. Select the Disk unit problem recovery
procedures option from the Work with
Disk Unit Recovery display.
e. Select the disk unit on the display that
is not configured.
f. Select the Download Licensed Internal
Code option from the Disk Unit Problem
Recovery Procedures display. Press
the Enter key to begin the download
and again when the download is com-
plete.
g. Select the Initialize and format disk unit
option from the Disk Unit Problem
Recovery Procedures display. When
the new disk unit is initialized and for-
matted, the display shows that the
status is complete (this may take 30
minutes or longer).
h. Press the Enter key.
9
Is most of the customer data recoverable
(see step 3 of this procedure)?
Yes No
~
Go to step 15 of this procedure.
1 0
Restore the customer data from the tape to
the new disk unit by doing the following:
a. Press F12 (Cancel) from the Disk Unit
Problem Recovery Procedures display.
b. Select the Restore disk unit data option
from the Work with Disk Unit Recovery
display.
c. Enter the tape volume identifier. This is
the volume identifier that you entered
during the save procedure.
d. Install the first tape that the data was
saved to in the tape unit.
e. Select the tape unit that you want the
data restored from on the Select Tape
or Diskette Unit display.
f. Select the disk unit that you want the
data restored to on the Restore Disk
Unit Data display.
The Restore Disk Unit Data display
shows the percent of customer data
restored.
After all customer data is restored from
the tape to the disk, the display shows
that the status of the restore operation
is complete.
g. Press the Enter key to complete the
restore operation.
h. Power off the system (see Powering Off
the System in Chapter 3, "Service Ref-
erenced Procedures" on page 3-1).
Note: Any damaged objects that were
restored during the restoring of the cus-
tomer data must be loaded again by
the customer. Have the customer see
the Backup and Recovery - Basic infor-
mation.
The system is ready for the next IPL.
This ends the procedure.
11
Perform an I PL from the tape unit and
install the Licensed Internal Code (see
"Licensed Internal Code Install and Restore
Overview" in the Service Functions infor-
mation for the system, which does an IPL
from the tape unit, installs the Licensed
Internal Code, and formats and initializes
disk unit 1 in the system unit). Then return
to step 12 of this procedure.
1 2
Recover the configuration to disk unit 1 in
the system unit by doing the following:
a. Select the Work with DST option from
the Install the Operating System
display.
b. Enter the password 22222222.
Note: If this password is not valid, ask
the customer for the correct password.
c. Select the Work with disk units option
from the Use Dedicated Service Tools
(DST) display.
d. Select the Work with disk unit recovery
option from the Work with Disk Unit
display.
e. Select the Recover configuration option
from the Work with Disk Unit Recovery
display. This option assembles the
system configuration information on
disk unit 1 in the system unit.
Notes:
1) A warning message appears stating
that recovering the configuration
destroys all system data unless the
load-source data is restored before
continuing past the DST main
display. You will return to the DST
Chapter 2. Recovery Procedures
2-7