System Processor - IBM AS/400 Repair And Parts Manual

System Processor
Warning: The system processor is sensitive to
electrostatic discharge. See Appendix A,
"Working with Electrostatic Discharge-Sensitive
Parts" on page A-1.
1
Power off the system. See Powering Off
the System in Chapter 3, "Service Refer-
enced Procedures" on page 3-1.
2
Disconnect the power cord.
3
Remove the covers. See "Covers" on
page 1-10.
4
Remove the access plate. See "Access
Plate" on page 1-2.
1-20
AS/400 9402/9404 Models 2xx Repair and Parts
5
If a card enclosure is installed, remove the
card enclosure. See "Card Enclosure" on
page 1-6.
6
If you are exchanging the system
processor, you must remove the main
storage cards. See "Main Storage Card" on
page 1-14.
7
Remove the screws and clips
II.
8
Release the card retainers
Ii!
or
Ill.
9
Hold the edges of the card above and
below the connector. Pull to remove the
card.
1 0
Install the system processor by reversing
the removal procedure.
This ends the procedure.