Table of Contents
Advertisement
Straight-line driving speed control of forklift truck transportation ≤5km/h, turning speed ≤3km/h; during
transportation, the spacing between goods and inserts should be adjusted to the maximum position of the
spacing between pallets.
During loading and unloading, except forklift operators, other personnel should keep within a safe distance to
ensure personnel safety.
Lifting the unloading
If a crane is used to unload the package, use a dedicated hoisting tool. Select a proper hoisting tool based on the
weight and size of modules. Use a fixing tool of the same size on the top of the package to prevent the lifting rope
from squeezing the package or modules.
Horizontal packaging can lift up to 4 sets of modules at a time, vertical packaging can lift up to 2 sets of modules
at a time.
Tran-shipment
If vertical packaging modules need to be transported to the construction project site through secondary
transportation after being transported to the centralized storage site by container or flatbed vehicle, the following
points should be noted:
If forklift truck is used for transport, the forklift truck shall comply with the above requirements for unloading,
and the forklift truck size shall be at least ≥ 3T;
If you use a box truck or other type of vehicle, please use a carriage with guardrail, the height of the guardrail is
not less than 2/3 of the height of the module, and use fastening straps to secure the module to the carriage; modules
should be placed closely with each other, and gaps should not be left.
If the vertical package is turned to horizontal by a turning machine, please note that the flat tray structure is
used as the bearing unit of the module after turning over, and only the frame surface of the module can be used as
the bearing surface of the module after turning over.
Retail packaging
If the modules are not filled when they are shipped, Hyundai Energy Solution uses wooden frames of the same
size as the modules as packing fillers. The wooden frames are located in the middle of the packaging body, and the
scattered packaging method is exactly the same as the integral packaging method.
Storage
Please store the modules in a dry and ventilated environment and place the modules on a relatively flat ground.
Ensure that the outer package of the modules is intact. Ensure that the pallets and packages are protected from
moisture and direct sunlight in the storage area, and take waterproof (rain) measures.
If the modules are stored in an uncontrolled environment, they must not be stored for more than 3 months.
Additional measures should be taken to protect the connector from moisture or sun exposure, such as using the
connector end cover;
Long-term storage of modules is recommended to be stored in a standard warehouse. Check for module tilt
anomalies periodically.
Advertisement
Table of Contents
