Table of Contents
Advertisement
Do not install modules without taking protective
measures.
Do not use any means other than connectors for
electrical connection.
Do not add any light concentrators to the module.
Fire Safety
Before installing modules on the roof, refer to local laws and regulations and comply with building fire protection
requirements. The roof shall be covered with a suitable grade of fireproof material for roof installation and to ensure
that the modules and mounting surfaces are fully ventilated. Different roof structures and installation methods can
affect the fire performance of a building. Improper installation may cause a fire.
Use appropriate components such as fuses, circuit breakers and ground connectors according to local regulations.
Do not install or use modules near open flames or flammable or explosive objects.
Transportation safety
Do not open the packing case before the modules arrive at the installation site. Place the packing case in a dry
and ventilated environment.
During all handling, ensure that the module will not be shaken, dropped to the ground, or objects will fall on the
module, as this will damage the module or the solar cells in the module. Do not allow children or unauthorized persons
to handle modules. Improper handling and placement may result in glass breakage or loss of electrical properties,
thus rendering the modules useless.
Handle and installation modules with care. Under no circumstances should assemblies be lifted by lifting junction
boxes or cables. Two or more persons must hold the edges of assemblies with both hands.
Do not step on, stand on or sit on modules as this can damage modules and risk injury to people.
Do not stack modules, do not place any heavy objects on the front and back of modules, and do not place
modules on sharp surfaces.
Install Security
Comply with safety rules applicable to all installed modules. Such as wires and cables, connectors, charging
controllers, inverters, batteries, etc., only the equipment, connectors, wires and rails that match the solar power
system can be used.
If the photovoltaic system uses energy storage batteries, the configuration of the modules should follow the
advice of the battery manufacturer.
Do not install or operate s in damp or windy conditions, and keep the junction box cover closed.
Do not coat the surface of the module with
corrosive chemicals.
Do not install or operate modules in damp or
windy conditions.
Do not touch the module when it is wet.
Advertisement
Table of Contents
