Machinery Installation; Location Choice - Hyundai UF Series Manual

Machinery Installation

Ensure that the module installation strong enough, supporting system composed of the phalanx system components must be able
to withstand the mechanical load pressure, appointed by it' s bracket installer must provide the guarantee, mounting bracket needed and
static mechanics analysis ability of the third party testing institutions to test, need to adopt international standards or national standards.
The mounting bracket of the component must be made of materials that are resistant to corrosion, rust and UV.
Modules must be securely mounted on system supports.
Do not drill additional mounting holes in the frame and glass. Otherwise, the module warranty will be invalid.
The support structure of modules has thermal expansion and cold contraction effect. To avoid affecting the performance and use
of modules, it is recommended that the minimum distance between the two modules is 10mm. To ensure good ventilation of modules
and reduce load, it is recommended that the installation distance between two modules is 30mm.
In areas with heavy snow in the winter, choose a high mounting bracket so that the lowest point of the module is not covered by
snow for a long time, and the lowest point of the module is high enough to prevent the module from being obscured by plants or trees.
The support surface of the installation bracket must be flat, without distortion or deformation, and there is no up and down
dislocation between the connected brackets.
The assembly installation method should not result in electro-chemical corrosion between the aluminum frame and different metals.

Location Choice

Roof
When installing on a roof or building, ensure that they are securely secured and will not be damaged or dropped by strong
winds or snow. Provide a special mounting bracket for roof installation if necessary. The building code used for roof installation
should be checked to ensure that the building and structure to which the modules are installed have sufficient load-bearing and
airtight properties. The roof through which the fixed modules are installed should be sealed to prevent rainwater leakage.
To facilitate operation, reduce water vapor condensation, and promote ventilation and heat dissipation for modules, ensure
that the modules are parallel to the surface of the wall or roof of the building. The distance between the modules and the surface
of the wall or roof is at least 115mm. In this way, the air circulation at the rear of the modules facilitates heat dissipation and
prevents cable damage. When stacking modules, ensure that the modules are installed on a fireproof roof. The module has a fire
rating of C and is suitable for installation on a roof with fire rating of A or higher.
For the roof system with heavy snow or snow record in the installation area, the customer shall support and reinforce the
bottom module frame of the entire system to ensure that the bottom module is protected from top-down snow push and pressure
damage and damage to the module caused by daytime snow melt and icing.