Troubleshooting Guide - Rowenta OPTIGRILL+XL Instructions For Use Manual

Troubleshooting guide

Problem
Button blinking
+
Indicator light
solid green
+ Button blinking
+ Button
light fixed
The appliance stops
during the cycle of pre-
heating or cooking.
The indicator light
will blink white
+
/ / /
button blinking
+ Intermittent beeping
The appliance no longer
beeps.
The indicator light
will blink white
+ Button blinking
+ Continuous beeping
36
Cause
• Switching on the
appliance or starting an
automatic cooking cycle
with food and without
plates preheating
(manual mode is
automatically activated).
• The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Appliance failure.
• Appliance stored or used
in a room that is too cold.
• Appliance failure.
Solution
• 2 possible options:
ū Choose the temperature
setting by pressing the
button and then press
OK. Allow to cook, but
you must monitor the
cooking (manual mode).
ū stop the appliance,
remove the food, close
the appliance properly,
re-program the appliance
and wait until end of
preheating.
• Disconnect the appliance
from the outlet and leave
for 2-3 mins., restart the
process. The next time you
use the appliance, make sure
you open and close it quick
for best cooking results. If
the problem occurs again
contact your local Rowenta
customer service.
• Disconnect and reconnect
your appliance and
immediately restart
a preheat cycle. If the
problem persists, contact
your Customer Service.
• Unplug the appliance and
contact customer service.