Vehicle Lights; License Plate Light - Yamaha MTM660N Owner's Manual

4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
5. After the fuse is changed, place
the battery cover in the original
position, and then install the bolts.
6. Install the diagnostic connector by
pushing it downward.
7. Install the seat holder by installing
the bolts, and then tighten the
bolts to the specified torque.
Tightening torque:
Seat holder bolts:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
8. Install the seat.
Periodic maintenance and adjustment

Vehicle lights

1. Headlight/Auxiliary light
Except for the license plate light bulb,
this model's lights are all LED.
If an LED light does not come on,
check the fuses and then have a
Yamaha dealer check the vehicle. If the
license plate light does not come on,
check and replace the bulb. (See page
7-32.)
NOTICE
Do not affix any type of tinted film or
stickers to the headlight lens.
7-32
EAU80380

License plate light

If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
1
ECA16581
EAU24331
7