Related Manuals for D-D The Aquarium Solution Aqua-Pro Reef 600
Summary of Contents for D-D The Aquarium Solution Aqua-Pro Reef 600
- Page 1 AQUA-PRO AQUARIUMS Installation Instructions For the Aqua-Pro Reef 600, 900 & 1500 models FOLLOW US FOR INSPIRATION! .com/theaquariumsolution .com/groups/ddaquapro www.theaquariumsolution.com...
- Page 2 D-D Aqua-Pro Reef Systemised Aquarium Please read the following installation instructions carefully before starting to assemble and run your aquarium. If correctly installed, your new aquarium should give you years of pleasure in this fantastic and enthralling hobby. STEP 1. POSITIONING THE AQUARIUM When positioning the tank it is important to have enough people to safely move the aquarium.
- Page 3 Metal Framed Cabinet Insert the pipe down the weir so that the threaded end goes through the hole. The metal frame cabinet comes with 6-8 adjustable feet, depending on model. Take the lower part of the main overflow pipe, which is fitted with a flow valve, remove any plastic wrap or tape Start by establishing if your floor is level by placing the from the end and ensure the rubber o-ring is in place.
- Page 4 For these two models only, push the nozzle assembly AQUA-PRO REEF 600 SUMP LAYOUT into place on the top of the return pipe in the weirbox. This should be positioned so that the open end(s) are facing and in line with the holes in the overflow comb.
- Page 5 adjustable baffle into position. Thread the plastic Simply unplug or turn off the return pump, the water screws through the open sections in the baffle plates level in the aquarium will then drop to the level of the and tighten the nut on the opposite side. The plates nozzle outlet and the weirbox will drain down level with can be fitted to either side of the glass dividers.
- Page 6 Adjusting the cabinet doors with an even gap, and close without any obstruction. The push-openers can also be adjusted by twisting them The doors are pre-set in the factory before packing in or out, by hand. but the hinges may need to be adjusted slightly once The hinges can show signs of rust over time if splashed the aquarium is in its final location.