Table of Contents
Advertisement
Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note:
can handle CVBS and RGB,
EXT. 1
It is preferred to connect peripherals with RGB output to
If your recorder is provided with the EasyLink function, it should be connected to
EasyLink functionality.
Recorder
(VCR-DVD+RW)
CABLE
2
2
EXT.
EXT.
EXT.
1
2
4
Other equipment
CABLE
1
4
2
Side connections
1
2
20
EXT. 2
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder's test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 7.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 10. You can also connect your decoder directly to
EXT. 1
(satellite receiver, decoder, DVD, games, etc.)
Connect the aerial cables 1, 2 and 3 as shown (only if your
&
peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of the
euroconnectors
é
Look for the test signal of your peripheral in the same way as you
do for a recorder.
"
Make a selection in the Setup, Source menu, p. 10.
3 5
Camera or Camcorder
&
Connect your camera or camcorder as shown.
é
Connect to
For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by connecting
the S-VHS cables with the S-video input 1 and audio inputs 3.
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
3
Headphone
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
CVBS, RGB and Y/C,
EXT. 3
or
as RGB provides a better picture quality.
EXT. 1
2
or
with a eurocable.
2
,
,
EXT.1
2
3
2 and
VIDEO
Headphone volume
and
only CVBS.
EXT. 4
to benefit from the
EXT. 2
or
to obtain a better picture quality.
4
3 for mono equipment.
AUDIO L
3.
AUDIO R
to adjust the
Advertisement
Table of Contents
