AJAX KeyPad TouchScreen Manual page 55

The system or the group is
switched to the Night Mode.
The system is disarmed.
System in the armed mode.
An incorrect code was
entered.
Error when adding a card/key
fob.
Successfully added card/key
fob.
Low battery.
Tamper triggering.
Jeweller/Wings Signal
Strength Test.
The built-in buzzer emits a
short beep.
The built-in buzzer emits two
short beeps.
The LED indicator lights up red
for a short time every 3
seconds if the external power
is not connected.
The LED indicator constantly
lights up red if the external
power is connected.
An appropriate noti cation is
shown on the display.
The built-in buzzer emits a
short beep (if adjusted).
An appropriate noti cation is
shown on the display.
The LED indicator lights up red
once.
The built-in buzzer emits a
long beep.
An appropriate noti cation is
shown on the display.
The built-in buzzer emits a
short beep.
The LED indicator smoothly
lights up and goes out when
the tamper is triggered, an
alarm is activated, or the
system is armed or disarmed
(if the indication is activated).
The LED indicator lights up red
for 1 second.
The LED indicator lights up
green during the test.
If noti cations for Night Mode
Activation/Deactivation are
enabled.
If noti cations for
Arming/Disarming are
enabled.
If Armed Mode Indication is
enabled.
The indication turns on when
the keypad switches to sleep
mode (the display goes out).
The beep loudness depends
on the con gured buttons'
volume.
The beep loudness depends
on the con gured buttons'
volume.
The beep loudness depends
on the con gured buttons'
volume.
Turns on after launching an
appropriate test in the