Advertisement
rs
ee
EET:
70
stereo) collar? |
Inserting a Blank Space
during Recording
This operation is possible only with the
remote commander.
1 Press O during recording at the
position where the blank space is to
be inserted.
REC indicator flashes and the tape
runs without recording. After 4
seconds, the unit enters recording
pause mode.
2 Press Il at the position where you
want to start recording again.
Recording restarts.
To make a blank of more than 4
seconds
Press Q as long as needed.
REC indicator flashes faster after 4
seconds have elapsed. The tape pauses
when @ is released.
To make a blank less than 4
seconds
Press REC @ while REC indicator is
flashing.
a
RELAY
aeD)
DIRECTION MODE
wy
Seok
ERE
I T
a p s
e e e
SPEED
°
5
PAUSE
Ci
ae
72
Tape Dubbing
(from deck A to B)
Whole Tape at
High Speed
This operation is not possible with the
remote commander.
1 Insert a recorded tape in deck A and
a blank tape in deck B.
2 Set the DIRECTION MODE selector.
To dub on one side: set it to ==.
To dub on both sides: set it to C> or
RELAY.
(See "Note on DIRECTION
MODE
setting page 74."')
3 Press HIGH SPEED.
The deck B enters recording pause
mode.
4 Choose the same direction on both
decks by pressing J or >.
To dub on one side, choose 4 or >.
To dub on both sides, choose >.
5 Press PAUSE Il.
Dubbing starts.
To stop dubbing
Press @.
74
Tape Dubbing
(from deck A to B)
Note on DIRECTION MODE setting
Position
"Operation
=
Dubbing stops at the end of
the tape.
SS.
When the tape in one deck
|
| comes to its end of the front
side, it reverses immediately
regardless of the tape
position in the other deck.
RELAY | When the tape in one deck
reaches its end of the front
side, it stops until the other
tape come to its end, and
then both tape reverse
together,
+
When dubbing starts from the reverse
side in the RELAY mode
At the end of the reverse side, dubbing
stops automatically.
Is It necessary to set DOLBY NR?
No. The tape in deck B is automatically recorded
in the same state as the tape in deck A.
if the direction indicator on ptay button flashes
3 times and disappears
The tab(s) of the cassette inserted into deck B
has (have) been removed. Dubbing is not
possible on that cassette. Cover the stot with
plastic tape. (See page 58.)
o
Advertisement
