Advertisement
DC-2212/220Z
COMPONENT
PARTS
REPLACEMENT
PROCEDURES
Replacement of Motor
1.
2;
3.
SrIHNDWSf
Remove lead wire of motor terminal. (See Fig. 3-5)
Remove set screw (1), and detach Relay board.
Remove set screw (2), and detach Motor holder. (See
Fig. 3-4)
Remove 2 set screws (3) of Motor, and detach Motor.
Pull out Motor pulley from Motor.
Attach Motor pulley to new Motor.
Adjust the height of Motor pulley. (See Fig. 3-4-1).
Attach Motor to Motor holder.
Motor
Motor
holder
Fig. 3-4
While applying the Belt on the flywheel side, attach
Motor holder to Tape transport unit
Apply Belt to driving pulley and pulley.
. Attach Relay board with screw Q).
Solder lead wire to motor terminal.
Fasten securely head lead and control lead with
binder.
. Adjust the tape speed.
Advertisement
