Sony PVW-2800 Operating Instructions Manual page 60

vt
§ cof
Fa £
&
Time codes can be recorded as direct input from an-external time code generator, or
generated from the built-in time code generator.
The built-in time code generator can be initialized manually with any value, or
locked to an external time code signal.
initializing the time code manually
Begin by setting the following switches on the system panel. To manipulate the
switches on the system panel, raise the lower control panel to a horizontal position.
EXT/INT switch + INT
REGEN/PRESET switch + PRESET
REC RUN/FREE RUN switch
— Select either mode*
NDF/DF switch - Normally DF**
G:..0. tr oo & ew OODU
cm | o{o000 00000900
System panel
*REC RUN:
The time code advances only during recording.
FREE RUN:
The time code advances regardless of the unit's
operating mode, until the power is tumed off.
4-4] Chapter 4 Recording and Playback
**DF:
The time code generator and CTL counter run in drop
frame mode.
NDF:
'The time code generator and CTL counter ren in
nondrop frame mode.