Table of Contents
Advertisement
Operation
@ Auto-play
(Basic procedure)
Open the upper cabinet gently.
Place a record on the turntable mat. (Fig. 6)
Close the cabinet gently.
Note:
The turntable will not rotate even if the start switch is pressed
without closing the cabinet.
Do not press controls until upper cabinet is closed.
. Press the power switch to the on (=) position. (Fig. 7)
The 33 speed selector LED lights up, as do the tonearm posi-
tion indicator and strobe illuminator/pilot lamp.
Press the start switch. (Fig. 8}
Note:
Wait about two seconds after you turn on the unit before
pressing the start switch.
This assures dependable and accurate operation.
The optical sensor will detect the record size and determine
record speed. According to size and speed, the tonearm will
automatically move to the lead-in groove and play will begin.
(Auto lead-in, auto-start.)
When, and only when, the tonearm is at the start position and
the record is 30 cm, pressing the cueing contro! will cause
automatic operation to begin (in the same way as if the start
switch is pressed).
When
there is no record on the turntable mat, the platter
will rotate several times but tonearm wil! not move.
At the end of the record the tonearm rises and automatically
returns to the start position.
{Auto-return)
.
After the tonearm
returns
to the start position, press the
power Switch to turn off the unit (#).
Note:
If you press the start switch for less than one second while a
record
is being played, the tonearm
returns to the lead-in
groove and begins playing the record again, The LED above
the
repeat
switch
flashes
on
and
off to indicate
that
this is happening.
If the cabinet is opened during play, the tonearm returns to
the start position.
If the power switch is turned off during play, the tonearm
rises above the record and stays at that position.
Then when the power is turned on again, the tonearm will
return to the start position.
@ Selective play
(Multi-function operation)
@ For normal and fast inward cueing
e
The tonearm will Keep moving
inward as long as you keep
the start switch depressed (for longer than 1 second).
répeal
cl
z
hal
—
:
e
If you press the start switch harder, the tonearm will move
inward faster.
e
lf you press the start switch intermittently, the tonearm will
move inward in small steps.
When you release the start switch, the tonearm will stop at
the position it has reached.
Press the cueing control again to lower the tonearm back
onto the record and begin play.
Refer to the Quick Reference Chart on page 12 for more
about start and stop operation.
Note:
A safety feature
of this unit ts that the tonearm
can only
be cued between the lead-in and lead-out grooves. There-
fore, you cannot cue the tonearm all the way back
to the start
position at the edge of the platter in the case of 17 cm (7")
and 25 cm (10") records. Instead, press the cueing control
once again to lower the tonearm onto the record, then press
the stop switch.
Advertisement
Table of Contents
