Armlift Height; Operation Settings; ( Led Color Setting / Reverse Playback Setting / 78 Rpm Setting / Torque Setting / Brake Setting) - Technics SL-1200M7L Owner's Manual

Armlift height

Make an adjustment according to your
cartridge if necessary.
Preparation
 Put a record on the turntable.
 Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
 Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
 The armlift height is factory-adjusted to
5
8 to 13 mm ( /
16
8 13 mm
to
( 5 / to 33 / " )
16 64
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
 Turning the screw clockwise lowers the
armlift.
 Turning the screw anti-clockwise raises
the armlift.
Armlift
33
to / ").
64
Armlift screw
Arm clamp

Operation settings

Allows for LED color setting, reverse playback
setting, 78 rpm setting, torque setting and brake
setting.
①Turn the unit off and pull out the power plug.
② A djust as desired by setting the switches with
a fine Phillips head screwdriver and the like.
ON
ON
OFF
Switch no.
1 2 3 4 5 6
LED color setting
Allows you to select red or blue for the color of the
strobe light, speed select buttons, pitch range select
button and RESET LED lamp.
Switch no.: 1 (LED)
OFF (Factory setting)
Red
Blue ON
Reverse playback setting
Allows you to disable or enable reverse playback. ( 19)
Switch no.: 3 (REV)
OFF (Factory setting)
REV disabled
REV enabled
78 rpm setting
Allows you to disable or enable 78 rpm. ( 19)
Switch no.: 4 (78)
OFF (Factory setting)
78 rpm disabled
78 rpm enabled
Torque setting
Allows you to select from four levels of strength to
adjust the torque.
Switch no.: 5 (TQ1)
High ① ON
OFF
②
③ OFF (Factory setting) OFF (Factory setting)
Low ④ ON
Brake setting
Allows you to select from four levels of brake strength
to stop the turntable after [START-STOP] is pressed.
Switch no.: 7 (BK1)
High ① OFF
② OFF (Factory setting) OFF (Factory setting)
ON
③
Low ④ ON
7 8
ON
ON
Switch no.: 6 (TQ2)
ON
ON
OFF
Switch no.: 8 (BK2)
ON
OFF
ON
(17)
English
17