Setting the Lower Limit:
While holding down both the M key and the 1 key, the digital display will
blink and show the real-time height. Use the UP or DOWN key to adjust
to the desired minimum height, then press S key to confirm and save the
setting.
Setting the Upper Limit:
While holding down both the M key and the 2 key, the digital display will
blink, showing the real-time height. Use the UP or DOWN key to adjust
to the desired maximum height, then press M key to confirm and save
the setting.
Setting the Base Height:
① Press the DOWN key to lower the desk to its minimum height.
② Hold the DOWN key for 10 seconds to enter the basic height setting
interface.
③ Use the UP or DOWN key to adjust the value (press the 3 key to switch
between adjustments). After adjusting the parameters, press the 1 key
and the 2 key to complete the setting.
Switching the Height Display Unit:
Press and hold both the M key and the 3 key simultaneously to switch the
display unit between centimeters (cm) and inches (inch).
Setting Anti-Collision Sensitivity:
Press and hold both the 2 key and the 3 key for 5 seconds simultaneous-
ly. The digital display will start flashing. Then, press either the 1 key, 2 key,
3 key, or the S key to configure the anti-collision sensitivity level: high,
medium, low, or default.
06
Need help?
Do you have a question about the MEMORY KEYPAD and is the answer not in the manual?