Center Of Gravity Camber Clamps - Permobil TiLite CR1 Service Manual

Replacing Parts on the TiLite CR1, continued

Center of Gravity Camber Clamps

Parts:
1. Camber Tube Bracket
2. Bottom Clamp Screws - M5x25 SHCS
3. Camber Tube
4. Strut
5. Strut Clamp
6. Strut Clamp Screw - M4x12 SHCS
7. Strut Bracket
8. Strut Spacers
9. Frame Clamp
10. Frame Clamp Screws - M5x16 SHCS
Removal:
1. Loosen and remove the bottom clamp screws and the camber tube bracket.
Installation:
1. With replacement camber tube bracket and bottom clamp screws in hand,
apply Loctite 242 on screws, ensuring coverage of at least three threads
toward the end of the screw.
2. Install camber tube bracket with bottom clamp screws into the strut. Make
sure the camber tube bracket is located at the temporary mark.
torque screws in 2Nm / 1.5 ft lb increments, switching between screws
until torque listed in images below pertaining to type of clamp on the wheelchair
is achieved. If clamp gap is significant, loosen screw on smaller clamp gap side
by at least one turn, re-torque opposite bolt to specified value, then re-torque
loosened bolt to specified value. It is acceptable to exceed specified torque value
by 2Nm / 1.5 ft lb to achieve better equivalence in clamp gap or until clamp gaps
are nearly equal. Repeat these steps for all bushings on the other side of the wheelchair.
3. Verify the camber tube is properly centered and that the wheels are properly towed.
Rear
Clamp
Gap
Permobil TiLite CR1 Service Manual
Progressively
Non Anti-Tip Camber Clamp
Torque to 6Nm / 4.5 ft lbs
Front
Clamp
Gap
Tools:
1. 4mm Hex Wrench
2. Torque Wrench
3. Loctite 242 (Blue)
4. Washable Marker
Strut Bracket
Strut Spacer
Strut Clamp
Strut Clamp Screw
Camber Tube
Bracket
Anti-Tip Camber Clamp
Torque to 8Nm / 6ft lbs
Rear
Clamp
Gap
10
Frame Clamp
Frame Clamp
Screws
Strut
Camber Tube
Bottom Clamp Screws
Front
Clamp
Gap