Table of Contents
Advertisement
1 | General
B
Frame feature plate
C
Electrical board feature plate
The equipment can be identified from:
Packaging plate.
- It shows the identification data of the equipment.
Frame feature plate.
- Affixed on the machine, it shows the technical and
performance data of the equipment.
Electrical board feature plate.
- Affixed on the panel from which the electrical board is
accessed, it shows the electrical data of the equipment.
If it is lost or deteriorated, request a duplicate from Technical
Support.
Tampering with, removal and deterioration of the identification
plates complicate any installation, maintenance and spare part
request.
1.7
Intended use
The units allow synergies to be created at plant level by offering the
possibility of recovering heat from industrial processes or to be
integrated with other technical systems that produce hot water at
medium temperature. Part of the energy produced can be used as a
heat source by the units to produce hot water at high temperature.
This unit is designed to heat water (possibly added with inhibited
ethylene glycol) which circulates in a closed circuit.
The hot water produced can be used for air conditioning systems or
for industrial processes.
The machine cannot be installed outdoors.
Any other use of the machine is forbidden.
Do not use flammable products near the machine.
Do not use substances that can form explosive mixtures close to
the machine.
Do not use the machine where there are problems of
environmental impact.
1.8
General precautions
These units must be installed by a qualified company that at the end
of the work provides the operator with a declaration of conformity
with the regulations in force and the instructions provided by the
manufacturer in this document.
These units must comply with their intended use in line with their
performance characteristics.
6
Wear suitable and accident prevention clothing and equipment
during installation and/or maintenance. The manufacturer declines
any liability for non-compliance with safety and accident prevention
regulations in force.
All unit installation, connection, start-up and shut-down operations
must only be implemented by qualified and authorised personnel.
Comply with the laws in force in the country where the machine is
installed, concerning the use and disposal of the packaging, the
products used for cleaning and maintenance and for the
management when the unit life cycle is complete.
Any repairs or maintenance must be performed by the technical
support of the manufacturer or by qualified personnel, in accordance
with this publication.
Preferably use original spare parts when replacing components.
If the refrigerant should leak, ventilate the room. The liquid
refrigerant produces toxic gas when exposed to a flame.
In the case of a malfunction or spill of liquid or gas refrigerant, set the
main switch to "off" and close the shut-off valves. Promptly call
technical support or professional personnel. Do not intervene
personally on the unit.
If the outside temperature can drop below zero, there is a freezing
hazard and the system must be drained or anti-freeze must be
added.
Based on CE Standard no. 842/2006 on certain fluorinated
greenhouse gases, it is mandatory to indicate the total amount of
refrigerant in the installed system. This information is present in the
technical plate found in the outdoor unit. This unit contains
fluorinated greenhouse gas covered by the Kyoto Protocol.
Maintenance and disposal must be carried out only by qualified
personnel.
1.9
Basic safety rules
Using products that require electricity and water require some basic
safety rules to be complied with, such as:
It is prohibited to operate the unit before having disconnecting it
from the power supply by setting the main switch to "off".
It is prohibited to modify the safety devices or the settings
without authorisation and instructions from the manufacturer of
the unit.
It is prohibited to pull, detach or twist the electrical cables
coming from the unit, even if it is disconnected from the power
supply.
It is strictly prohibited to touch any moving parts, stand between
them or introduce pointed objects through the grids.
It is prohibited to use gas and water pipes to earth the unit.
It is prohibited to touch the unit when barefoot or with wet or
damp parts of the body.
It is prohibited to stand on the unit, sit down on it and/or lean
any type of object against it.
It is prohibited to dispose of and leave the packaging material in
the reach of children as it can be a potential source of danger.
It is prohibited for children or unassisted disabled persons to use
the unit.
It is forbidden to release R134a into the atmosphere: R134a is a
fluorinated greenhousegas, recalled in the Protocol of Kyoto,
with a Global Warming Potential (GWP)= 1975.
It is forbidden to release R513A into the atmosphere: R513A is a
fluorinated greenhouse gas, recalled in the Protocol of Kyoto,
with a Global Warming Potential (GWP)= 1975.
Advertisement
Table of Contents
