Table of Contents
Advertisement
3.
INSTALLATION METHOD
Wired Remote Controller Dimensions
Remove the backing plate from the wired controller
•
Insert a flat screwdriver into the
slots in the lower part of the wired
controller (2 places). Rotate the
screwdriver (2 places) to remove the
backing plate (Figure 2).
Do not pry up and down, you can only rotate the screwdriver.
NOTE
Rinnai
Figure 1. Dimensions
Srewdriver
locations
Figure 2. Backing plate removal
9
DRCi R32 Wired Controller OIM
Backing
plate
Advertisement
Table of Contents
