Making System Connections - Onkyo TX-SV424 Instruction Manual

Making system connections
e Do not plug in the power cord until all connections have been made.
e On each pair of input jacks, the lower jack (marked R) corresponds to the right channel, and the upper jack (marked L) to the
left channel.
e Please refer to the instruction manual of each component when making any connections.
Connect the output leads of the turntable to
the PHONO input jacks.
Be sure to connect the ground (earth) lead
wire from the turntable to the ground ter-
minal (GND). Turntables not provided
with ground wires do not need to be con-
nected in this way.
Place the turntable on a firm shelf or deck
free from vibrations (especially those gen-
erated by the speaker system). If the turnta-
ble can pick up such unwanted vibrations,
not only will the performance of the unit
drop, but distortion in the bass frequencies
and howling in the speakers may also
occur.
e@ This unit is designed for use with turn-
tables using moving magnet cartridges.
Connect a compact disc player to the CD
input jacks.
This unit has facilities for two tape decks.
If you are using only one tape deck, con-
nect it to the TAPE-1! jacks. If you have
two tape decks, connect one to the TAPE- |
jacks and the other to the TAPE-? jacks.
If you wish to use a graphic equalizer as
well as two tape decks, connect the graphic
equalizer to the TAPE-2 jacks, and connect
the second tape deck to the tape jacks on
the graphic equalizer. (See the diagram.)
Connect the OUTPUT jacks on the graphic
equalizer to the TAPE-2 PLAY jacks on
the TX-SV424, and the INPUT jacks to the
TAPE-2 REC jacks as shown.
See page 22 on how to use a graphic equal-
izer.
INPUT OUTPUT REG PLAY
TX-SV424 Graphic Equalizer Second Tape Deck