Table of Contents
Advertisement
3. Optional: Enter the PIN code on the product label for increased security during enrollment. The
device does not pair with the panel if you enter an incorrect PIN code.
4. Tap Pair.
5. Plug in and power on the device.
Result: The device enrolls successfully.
Considerations when you enroll a device
The following considerations apply when you enroll a device with PowerG or when you enroll a
device with Auto Learn enroll.
•
If the buttons remain pressed after the light is turned off, the device returns to low-power
mode.
•
If the connection is successful, the PowerG signal strength displays on the device and the
enrolled status on the control panel.
If the connection fails, a Not enrolled status indicates on the control panel.
•
Checking the PowerG signal strength of the device
1.
Ensure that the IQ Outdoor Plug-PG is powered on.
2.
On the IQ panel, tap Settings > Advanced Settings > Enter Installer Code > Installation >
System Tests > PowerG Test > Run.
PowerG signal strength indication
Table 1: PowerG signal strength
Signal strength
Strong
Good
Poor
4
IQ Power Switch-PG Installation Guide
LED color and pattern
LED turns green and flashes 3 times
LED turns orange and flashes 3 times
LED turns red and flashes 3 times
D-308963 IQ Power Switch-PG Install Guide
Advertisement
Table of Contents
