JVC HD-ILA HD-61Z585 User Manual page 70

WARNING: DO NOT a ttempt toremove the assembly until the tamp h as fully c o0ied, ifYou
feet a ny heat near the tamp, STOR a nd wait u ntil the lamp h as EULLY COOLED.
NEVER attempt toiemove the Iamp W ith the television plugged into anout]et.
DO NOT D ROP the Used lamp. The inside Of the!amp i sUnder Pressure. Dropping Or O ther
hard shock C0u]d cause the lamp t oshatter.
ALWAYS recycle the used t amp. Because the lamp c ontains asmall amount ofmercury, it
cannot bethrown away wit h reguJar trash. Fo!bvv the recycling instructions inc!uded with the
Lamp Replacement Kit.
6) Remove the lamp unit.
Using a Phitips head type screwdriver (cross-head type), loosen the two screws fastening the
lamp unit. When the screws have been loosened, remove the lamp by raising the handle and
gently sliding the unit straight towards you. Place it carefully in the recycling packaging.
Be sure to tighten the screws
\
\
\
\
7) Install the new _amp unit.
Holding the handle attached to the new lamp unit, slide and push the new lamp straight into the
television and back into the lamp housing area. Do not forget to re-tighten the two screws.
Note: If the lamp does not sit securely in the TV (fiat in the tamp housing area), it won't turn on.
Make sure the lamp sits securety and flat in the housing area.
WARNING!
Remember it is very important that YOU DO NOT TOUCH THE LAMP SURFACE. Please
read the warn}rigs on page 67 again.
Also, replace the lamp with part number TS-CLtt0U only! The television is designed
to work specifically with this lamp. Lamps other than TS-CL110U may cause
malfunctions and/or other damage to the television.
NOTICE (for USA)
This product has a High intensity Discharge (HID) lamp that
contains a small amount of mercury. Jt also contains Jead in some
eomponents. Disposal of these materials may be regulated in your
community due to envbonmental considerations. For disposal or
recycling information, please contact your Iocat authorities, or the
Ebctronics Industries AIJiance: http:i/www.eiae.org
To purchase a replacement lamp kit, please call 1-800-252-5722.