Honda FC600 Owner's Manual page 22

OPERATION
OPERATING THE CONTROLS FOR TILLING
If the tines dig іп but the machine will not move forward, move the handlebars
from side-to-side. When turning, push down on the handlebars to bring the
tiller's weight to the rear; this will make turning easier.
Handlebar Height Adjustment
Stop the engine before adiusting
the handlebar height.
To adjust the handlebar height:
1. Remove the 10 x 80 mm flange
bolt.
2. Loosen the 10 x 85 mm flange
bolt.
3. Reposition the handlebar.
4. Reinstall and tighten the 10 x
80 mm flange bolt.
5. Tighten the 10 x 85 mm flange
bolt.
Clutch
When the clutch lever is squeezed,
the clutch is engaged, power is
transmitted to the transmission,
and the tines turn.
When the lever is released, the
clutch is disengaged, and power is
not transmitted.
20
HANDLEBAR
HEIGHT
ADJUSTER
10 x 85 mm FLANGE BOLT
HANDLEBAR
10 x 80 mm FLANGE BOLT
CLUTCH LEVER
DISENGAGED