Advertisement
Available languages
Available languages
Run power cable to installation
location. Place the hood
at its location.
Using a pen, mark the position
of the
screws (smaller part of the key holes). Remove the hood
and install the (8) 1/2"
double
thread screws leaving
a 1/8"
gap (4 screws for 30"
hood). Remove wiring
cover and set aside. Place the wire clamp,
insert the
hood and tighten
the wire clamp
to secure the cable.
Place the hood under the cabinet and slide it in position.
Make sure the adapter
enters the ductwork.
Secure the
hood by tightening
the screws completely.
_
WARNING:
Risk of electrical shock. Electrlcal wiring
must be done by qualified
personnel in accordance
with all appllcable
codes and standards.
Before connecting wires, switch power off at service panel
and lock service disconnecting means to prevent power from being switched
on accidentally.
1. Connect
cable
to wiring
box using wire connectors.
Connect
BLACK to BLACK,
WHITE
to WHITE,
and
GREEN
wire under
second
ground
screw.
Reinstall
wiring
cover. DO NOT FORGET TO CONNECT
THE
GROUND.
_E0008
1) Ground
screw
l
i
i
i <
Advertisement
