Repairing; Troubleshooting - Stihl FSA 200.0 R Instruction Manual

19 Repairing

► If no grease can be seen on the end of the
screw plug (2):
► Screw in the tube of STIHL gear lubri‐
cant (1).
► Squeeze 5 g of STIHL gear grease into the
gear housing.
► Unscrew the tube of STIHL gear lubri‐
cant (1).
► Refit and firmly tighten the screw plug (2) .
► Run the brushcutter for 1 minute without
load.
The STIHL gear lubricant is evenly distrib‐
uted.
18.3 Sharpening and Balancing a
Metal Cutting Attachment
Correctly sharpening and balancing metal cutting
attachments requires a lot of practice.
STIHL recommends you have metal cutting
attachments resharpened and balanced by a
STIHL servicing dealer.
► Sharpen the metal cutting attachment as
described in the instructions and on the pack‐

20 Troubleshooting

20.1 Troubleshooting the brushcutter or battery
Fault LEDs on the
battery
The brushcutter 1 LED flashes
does not start green.
when switched
on.
1 LED lights
up steady red.
3 LEDs
flash red.
3 LEDs light
up steady red.
4 LEDs flash
red.
0458-041-9601-A
aging supplied with the cutting attachment you
are using.
19 Repairing
19.1
The trimmer and cutting attachment cannot be
repaired by the user.
► If the trimmer or cutting attachment is dam‐
aged: Do not use your trimmer or cutting
attachment and contact your STIHL servicing
dealer.
19.2
The battery requires no servicing and cannot be
repaired.
► If the battery has a malfunction or is damaged:
Replace the battery.
Cause
The state of charge of
the battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
The brushcutter is too
hot.
There is a fault in the
battery.
No electrical contact
between brushcutter
and battery.
Repairing the Trimmer and
Cutting Attachment
Servicing and Repairing the
Battery
Remedy
► Recharge the battery fully as described in
the user manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use the brushcutter and contact a STIHL
authorized dealer for assistance.
► Remove the battery.
► Allow the brushcutter to cool down.
► Remove the battery and reinsert it.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Remove the battery.
► Clean the electrical contacts in the bat‐
tery compartment.
► Insert the battery.
English
49