Midea MC-SU60-RN1L Operation Manual page 30

Hide thumbs Also See for MC-SU60-RN1L:

4.2.3 Note to installation of wire controller:

1) This installation manual contains information about the procedure

of installing Wired Remote Controller. Please refer to Indoor Unit

Installation Manual for connecting between Wired Remote

Controller and Indoor Unit.

2) Circuit of Wired Remote Controller is low voltage circuit. Never

connect it with a standard 220V/380V circuit or put it into a same

Wiring Tube with the circuit.

3) The shield cable must be connected stable to the ground, or

transmission may fail.

4) Do not attempt to extend the shield cable by cutting, if it is

necessary, use Terminal Connection Block to connect.

5) After finishing connection, do not use Megger to have the insulation

check to the signal wire.

Table of Contents