Nano Temper Prometheus Panta User Manual page 8

Do not look directly into the UV-LED during operation. If used as intended, the instrument emits no UV
radiation.
CAUTION Mechanical moving parts within the instrument can pinch or injure your hands or fingers. Do
not touch or open the instrument while parts are moving. Do not reach into the opening when the door is
open.
CAUTION The display pane is made of glass. Broken glass can injure your hands or fingers.
CAUTION The sharp edges of the Prometheus Panta thermal element pose a risk of injury to hands and
fingers.
CAUTION The instrument contains a temperature regulator to control the sample temperature. Some
accessible parts of the instrument can reach temperatures of up to 60 °C. Don't touch the temperature-
controlled parts of the instrument when the temperature controller is set to high temperatures.
CAUTION Do not use the instrument at ambient temperatures below 15 °C.
CAUTION Use the instrument only at noncondensing conditions (20-70 % humidity, 15-30 °C). At very
high humidity levels, even normal operating temperatures may result in condensation and corrosion.
CAUTION Turn off the instrument when not in use.
CAUTION Do not use 100% ethanol or other types of organic solvents to clean the instrument as they
may remove the instrument paint.
CAUTION The instrument contains a laser module (visible
laser radiation class 3B according to IEC 60825-1: 2014).
Lasers or laser systems emit intense, coherent
electromagnetic radiation that has the potential of causing
irreparable damage to human skin and eyes. Direct eye
contact can cause corneal burns, retinal burns, or both, and
possible blindness. Do not attempt to open the instrument as this poses a risk of personal injury or
damage to the instrument. When the instrument is used as intended it emits laser radiation of LASER
CLASS 1.
CAUTION Remove loose parts (capillaries and capillary lid) before transport as they may damage the
measurement optics
CAUTION The heating element contains nickel. If allergic to nickel wear protective gloves when cleaning
the tray surface to avoid skin irritation and damage.
CAUTION If liquids penetrate the instrument, for example due to spillage, stop operation of the
instrument, disconnect it from the power supply and contact NanoTemper Technologies GmbH.
NOTE Insufficient air supply can cause overheating of the system. Assure enough air supply by not
covering or obstructing the back of the system.
NOTE Do not install the instrument in a location where it may be exposed to direct sunlight.
8/22