Option Settings; Osd Ur; Auto Keystn; Auto -Y-Pb- Ph - Panasonic PT-LC75U Operating Instructions Manual

Option settings
Use the A and V buttons on the
projector or remote control unit to
select an item, then press the < or
> buttons to change the setting.
OPTION!
"ETE {4 ON )
AUTO KEYSTN 4 ON >
AUTO Y-PB-PR4 ON P
AUTO RGB IN 4 ON H}
IRGB2 SELECT 4 INPUT P
RGB FORMAT — (Y-PB-PR P»
$ sELOT()6DJ [ESC
OPTION?
BACK COLOR { BLUE }
RONT/REAR 4 FRONT
IDESKYCEILING(€ DESK |j
LAMP POWER 4 HIGH M
LAMP RUNTIME — 10H |
FUNC 1. — (4 INDEX H|
$ SELCT 4) ADJ NE SC
OSD
ON
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
OFF
Use this setting when you do not
want the current input name to be
displayed.
AUTO KEYSTN
This should normally be set to ON.
ON
During automatic setup, the angle of
tilt of the projector is detected and
Keystone distortion is corrected
automatically.
OFF
se this setting when you do not want
automatic keystone correction to be
carried out during automatic setup,
such as when the screen itself is at
an angle.
36
HDTV60 automatically
HDTV50 on
he [becomes
signal status,
| Valid
RGB or YPsBPR is
selected automatically
depending on the
synchronising signal
status.
AUTO RGB IN
This should normally be set to ON.
ON
During automatic setup, the
projector selects whichever one of
the RGB1 IN or RGB2 IN
connectors has a signal being input,
and uses that signal for projection.
(If a picture is being projected, the
signal source is not automatically
changed.)
OFF
Use this setting when you do not
want the signal source to be
changed automatically during
automatic setup.
RGB2 SELECT
RGB2 SELECT (4 INPUT )
4
This setting is used to select the
function of the RGB2 IN/RGB1 OUT
connector.
setting