Using The D.zoom (Digital Zoom); Tudchuord Ascendant - Panasonic PT-LC75U Operating Instructions Manual

Using the D.ZOOM (digital zoom)
function
This function lets you enlarge a
single section of the picture.
Furthermore, the spot display mode
which is used to select the section
which is to be enlarged can also be
used when making presentations.
Press a D.ZOOM +/- button.
The projector will change to spot
display mode.
Cost Analysis
@ Use the A, V, < and >
buttons to move the spot to the
section which you would like to
enlarge, and then press the
ENTER button.
The area around the spot will
then be enlarged to twice the
normal size.
30
(3) Use the D.ZOOM +/- buttons to
change the enlargement ratio.
The enlargement ratio can be
changed within the range of x1 to
X2, in steps of 0.1.
NOTE:
@ When RGB signals are being
input, the enlargement ratio can
be changed within the range of
x1 to x3.
@ Press the MENU button to
return to the normal screen.
The projector will not return to
spot display mode at this time. To
return to spot display mode, clear
the enlarged picture display from
the screen and then press a
D.ZOOM +/- button again.
NOTE:
e This function can only be used
when using the remote control
unit.
€ |f the type of signal being input
changes while the digital zoom
function is being used, the digital
zoom function will be cancelled.