American Standard DetectLink 6072121 Manual page 10

9a
MAKE WIRED CONNECTIONS: BATTERY VERSION
Note: This step is only applicable for the battery
version.
Important: Align the polarity markings (7) on the
wire ends when making the connections.
1. Connect the SOLENOID WIRE (1) to the RED
AND BLACK WIRE (2) in the flush valve head.
2. Connect BLACK AND PURPLE WIRE (5) to the
BATTERY PACK (6) within the top of the flush
valve head.
3. Place the BATTERY PACK (6) within the top of
the flush valve head.
Note: Do not tighten flush valve head at this point.
9b
MAKE HOLE FOR AC WIRE
Note: This step is only applicable for the AC version.
1. Secure FLUSH VALVE HEAD (1) on to the flush
valve body.
2. Using the WIRE CHANNEL (2) as a template,
mark the drill location on the wall.
3. Make an opening in the wall at the marked
location.
IMPORTANT: The hole diameter should be no
smaller than the wire channel and no larger than
the wire channel escutcheon cover.
2
5
1
6
7
1
2