Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PO Fung Electronic GT-68 Series
Summary of Contents for PO Fung Electronic GT-68 Series
- Page 1 GT-68 SERIES FRS Two-way Radio OWNER’S MANUAL...
-
Page 2: Content Of The Packaging
ATTENTION! The radio is a multitask FRS transceiver. Combining the latest technology in radio communication along with a sturdy mechanical frame, the radio is the ideal and effective solution for the professionals who need to stay in touch with the working team (in construction sites, buildings, shows, trade fairs or hotels) or for leisure users that just want to keep up with friends and family. -
Page 3: Radio Overview
Radio Overview... -
Page 4: Main Features
Main features • 22 Channels • Output power: 462.5500-462.7250MHz: 31.56dBm, 467.5625-467.7125MHz: 26.88dBm • Channel spacing: 12.5 KHz • Channel Scan • Vocal tuning • Battery save • Channel Monitor • Squelch • 2pin Kenwood accessory jack • TOT (Time out timer) •... -
Page 5: Installing The Belt
Installing the Belt To install the Belt Clip, slide the clip down into the slot on the back of the radio until the Belt Clip-latch clicks. To remove the Belt Clip, press the Lock-tab down, and then gently pull the belt clip up toward the top of the radio. External Speaker/Microphone Jack Each radio can be used with an optional external speaker/microphone or headset, freeing your hands for other tasks. -
Page 6: Charging The Battery
headset jack, and then plug in the headset. Important: Your radio is not submersible or waterproof when using a headset jack. When you remove the headset, be sure to fully press the jack cover into place to restore its waterproof capability. Charging the Battery Charging the Radio To avoid the risk of personal injury or property damage from fire or electrical shock, only use the accessories specifically... - Page 7 Monitor The Monitor feature is for excluding (opening) the Squelch, in order to listen to signals that are too weak to keep the Squelch permanently opened. Hold down the Monitor to enable such function. Scan This function can be activated only by means of the optional programming software. To enable the Scan function, all 16 channels must be programmed.
- Page 8 off the prompt voice function, there is only a “beep” prompt when you turn on or operate the encoder. Emergency alert function If necessary, you can pre-program the Monitor into the Alarm function via CPS programming software. Turn on the radio, short press the Monitor to turn on the alarm function. Press the Monitor again to release the emergency alarm status.
-
Page 9: Appendix C. - Technical Specifications
The battery may be installed improperly. Remove and reattach the battery. The battery power may run out. Recharge or replace the battery. You cannot turn on the radio. The battery may suffer from poor contact caused by Clean the battery contacts or replace the dirty or damaged battery contacts. -
Page 10: Important Notice
Working temperature -10℃ to +40℃ Operation Voltage DC 3.7 V ±10% RF Output Power 462.5500-462.7250MHz: 31.56dBm, 467.5625-467.7125MHz: 26.88dBm FM Modulation 11K0F3E@12.5KHz Spurious Emission -13dBm＜1GHz， -13dBm＞1GHz Transmission current ≤1000mA Receive current ≤380mA NOTE: All specifications may be modified without prior notice or liability. IMPORTANT NOTICE WARNINGS: Replacement or substitution of transistors, regular diodes or other parts of a unique nature,... - Page 11 the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new model is a available for sale to the public, it must be tested and certified to the FCC/ISEDC that it does not exceed the exposure limit established by the FCC/ISEDC Tests for each product are performed in positions and locations as required by the FCC/ISEDC.
-
Page 12: Important Tips
compromettre le fonctionnement. ISEDC expositon aux radiations Cet équipement est conforme avec ISEDC les limites d’exposition aux rayonnements definies pour un contrôlé environnement. Cet émetteur ne doit pas être co-localisés ou fonctionner en conjunction avec une autre antenne ou émetteur. Cet équipement doit être installé... -
Page 13: Hazardous Environments
4. For vehicles with an air bag, do not place the product in the area over the air bag or in the air bag deployment area. 5. Keep the product and its accessories out of reach of children and pets. 6. -
Page 14: Maintenance Instructions
6. Overcharge shall always be prohibited for it may shorten the life of your battery. Maintenance Instructions ■ To help your battery work normally or prolong its life, be sure to observe the following instructions: 1. Accumulated dust on charging connector may affect normal charging. Please use a clean and dry cloth to wipe it on a regular basis. - Page 15 Disclaimer The Company endeavors to achieve the accuracy and completeness of this manual, but no warranty of accuracy or reliability is given. All the specifications and designs are subject to change without notice due to continuous technological development. No part of this manual may be copied, modified, translated, or distributed in any manner without the prior written consent of the Company.
- Page 16 Print version: GT-68(V1)_FRS_ V1.0...
Need help?
Do you have a question about the GT-68 Series and is the answer not in the manual?
Questions and answers