PO Fung Electronic MP23 Series Owner's Manual

Frs two-way radio

Advertisement

Quick Links

MP23/T23 SERIES
FRS TWO-WAY RADIO
OWNER'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MP23 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for PO Fung Electronic MP23 Series

  • Page 1 MP23/T23 SERIES FRS TWO-WAY RADIO OWNER’S MANUAL...
  • Page 2: Content Of The Packaging

    ATTENTION! The radio is a multitask FRS transceiver. Combining the latest technology in radio communication along with a sturdy mechanical frame, the radio is the ideal and effective solution for the professionals who need to stay in touch with the working team (in construction sites, buildings, shows, trade fairs or hotels) or for leisure users that just want to keep up with friends and family.
  • Page 3: Main Features

    Main features • 22 FRS Channels • Output power: ≤2W (channels 1-7and 15-22) • 12 NOAA Weather Channels • NOAA Weather Scan • 2 Channels Watch • Privacy Codes Scan and Store • Channel Monitor • Channel Scan Function • 155 Privacy Codes (50 CTCSS codes/ 105 DCS codes) •...
  • Page 4 Install the Li-ion Battery (BL-T22) Each radio operates with either a Li-ion battery pack or optional 3 AA alkaline batteries. The belt clip should be removed (see below) to ease installation or removal of the batteries. • Install 1) Remove the belt clip as described in the previous paragraph. 2) Insert the battery pack into the appropriate compartment of the device.
  • Page 5: Charging The Battery

    explosion when charging alkaline batteries. 1) Turn the radio off. 2) With the back of the radio facing you, lift the battery cover latch up and remove the cover. 3) Insert the three AA Alkaline batteries with + and – polarity as shown inside (Installing the batteries incorrectly will prevent the unit from operating or may damage the unit).
  • Page 6: Using The Charging Cradle

    1) Connect the included AC adapter with Type-C USB connector cable to the radio's Type-C USB port. Connect the other end to an outlet that provides USB charging power (NOT to a USB hub). 2) Charge the batteries for 6 hours until the battery indicator either stops flashing. Using the Charging Cradle 1) Connect the included AC adapter with USB connector cable to the charging cradle's Type-C USB port.
  • Page 7 Main controls and parts of the radio 1. Antenna 2. LCD Display UP button - Press to increase the volume. Menu mode to change settings in MENU. /MENU- Press this control to enter the radios MENU. If you keep it pressed for about 3 seconds, the keypad lock is activated.
  • Page 8: Basic Operations

    LCD DISPLAY 1. NOAA Weather Band Indicator 2. Scan Indicator 3. Activate the VOX function 4. Dual Channel Monitor 5. Select the DCS/CTCSS type of squelch method 6. Channel (1-22) 7. Battery Indicator 8. Emergency alert function activated 9. Transmit Status 10.
  • Page 9: Talking On Your Radio

    Talking on Your Radio To talk to others using the radio: 1) Press and hold the [PTT] button and speak in a clear, normal voice about 2-3 inches away from the microphone. While you are transmitting, the TX icon appears on the display. To avoid cutting off the first part of your transmission, pause slightly after pressing the [PTT] button before you start talking.
  • Page 10: Using The Flashlight

    A flashing "CTC/DCS" will be in the left status display to indicate the radio is in Sub-Codes scanning mode. In this mode, the lower display will cycle through the Sub-Codes as they are being tested. Once the bits of the received Privacy code are determined, the "CTC/DCS"...
  • Page 11: Menu Options

    1) To turn the NOAA Weather Scan on, press and hold the [ /MONI] button for 5 seconds while in FRS mode, icon appears. The radio will go to Weather band mode and start scanning all 12 channels and stop on any active channel. When the channel becomes inactive for 10 seconds the radio will resume scanning.
  • Page 12: Selecting The Channel

    Selecting the Channel The channel is the frequency of the radio uses to transmit. Your radio has 16 channels and 155 Sub-Codes you can use to talk to others. In order to speak to someone, both your radios must be set to the same channel and Privacy code. 1) Press and hold the [ /CALL] button until the radio is turned on.
  • Page 13: Setting And Transmitting Call Tones

    • 1 = high sensitivity (normal voice with no background noise) • 2 = Medium Sensitivity for most environments • 3 = low sensitivity (useful in very noisy areas or if you talk loudly) 3) Press the [PTT] button to exit menu or [ /MENU] button to continue set up. To disable the VOX function follow the instructions above and select option oF (OF: Disabled).
  • Page 14: Keypad Beep

    3) Press the [PTT] button to exit menu or [ /MENU] button to continue set up. WARNING: The Distress Alert feature should only be used in a true emergency. If the receiving group does not respond to the distress signal, Baofeng will not assume any responsibility. Keypad beep To deactivate the keypad beep, follow these steps: 1) Press the [ /MENU] button 7 times and until “...
  • Page 15: Technical Specifications

    Note: If you set the same channel and Sub-code as the current channel, Dual Watch doesn’t work. 5) Press the [ /SCAN] button to turn the Dual Watch mode OFF. Technical Specifications General Part Frequency Range Channels 22 FRS/12 Weather Sub-Codes 50 CTCSS Tones/ 105 DCS Codes Working temperature...
  • Page 16: Appendix B. - Trouble Shooting Guide

    Appendix B. – Trouble shooting guide Phenomena Analysis Solution The battery may be installed improperly. Remove and reattach the battery. The battery power may run out. Recharge or replace the battery. You cannot turn on the radio. The battery may suffer from poor contact caused by Clean the battery contacts or replace the dirty or damaged battery contacts.
  • Page 17 Appendix C. –FRS Frequency Chart (MHz) CH.No CH.Freq. RF Power CH.No CH.Freq. RF Power High 462.5625 467.6625 462.5875 High 467.6875 462.6125 High 467.7125 462.6375 High 462.5500 High 462.6625 High 462.5750 High 462.6875 High 462.6000 High 462.7125 High 462.6250 High 467.5625 462.6500 High 467.5875...
  • Page 18: Appendix E. - Dcs Table

    Appendix E. - DCS Table DCS CODE LIST Number Code Number Code Number Code Number Code Number Code D023 D025 D026 D031 D032 D036 D043 D047 D051 D053 D054 D065 D071 D072 D073 D074 D114 D115 D116 D122 D125 D131 D132 D134 D143...
  • Page 19: Appendix F. - Ctcss Table

    Appendix F. - CTCSS Table CTCSS CHART (Hz) Number Frequency Number Frequency Number Frequency Number Frequency Number Frequency 67.0 69.3 71.9 74.4 77.0 79.7 82.5 85.4 88.5 91.5 94.8 97.4 103.5 107.2 110.9 114.8 118.8 123.0 127.3 131.8 136.5 141.3 146.2 151.4 156.7...
  • Page 20 FCC & RSS WARNINGS: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value.
  • Page 21: Electromagnetic Interference/Compatibility

    L’exploitation est autorisée aux deux conditions suivantes: (1) I’areil ne doit pas produire de brouillage, et (2) I’utilisateru de I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. ISEDC expositon aux radiations Cet équipement est conforme avec ISEDC les limites d’exposition aux rayonnements definies pour un contrôlé...
  • Page 22: Important Tips

    This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference received, including interference that may cause undesired operation of the device.
  • Page 23: Hazardous Environments

    proper location for cooling. 8. Handle the product with care. 9. Do not disassemble, modify or repair the product and its accessories without authorization. Hazardous Environments ■ Do not operate the radio in hazardous environments. Explosion or fire may result. Do not operate the radio near unshielded electrical blasting caps.
  • Page 24: Transportation Instructions

    regular basis. 2. It is recommended to charge the battery under 5℃~40℃. Violation of the said limit may cause battery life reduction or even battery leakage. 3. To charge a battery attached to the product, turn it off to ensure a full charge. 4.
  • Page 25 We do not guarantee, for any particular purpose, the accuracy, validity, timeliness, legitimacy or completeness of the third-party products and contents involved in this manual. PO FUNG ELECTRONIC (HK) INTERNATONAL GROUP COMPANY LIMITED Room 1508, 15/F, Office Tower II, Grand Plaza, 625 Nathan Road, Kowloon, Hong Kong Http://www.baofengradio.com...

This manual is also suitable for:

T23 series

Table of Contents