Husqvarna Blastrac EBE 350 Operator's Manual page 13

3. Put the side seal (B) in the side seal box. Make sure
that the rounded part of the side seal points to the
front of the product.
B
4. Use an applicable tool to hold the side seal in
position while a second person operates the product
down the ramp.
WARNING:
operate the product down the ramp.
There is a risk of pinching.
5. Do the procedure on the other side of the product.
6. Make sure that you can see the 2 axles of the side
seal spring plate on top of the side seal box.
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive material on page 32 .
Refer to
2111 - 001 - 21.07.2023
Be careful when you
Separator
The separator (A) holds the abrasive material and
supplies the blast wheel blades with abrasive material
through the hopper (B).
A
B
The separator tray keeps contamination away from the
abrasive material and the blast wheel blades.
To fill the product with abrasive
material
WARNING:
protective equipment when you fill the
product with abrasive material. Refer to
Personal protective equipment on page 6 .
Always use personal
13